MACHINING OIL -All metals that are difficult to machine

CHARACTERISTICS :

The machining oil has wetting, penetrating and extreme pressure properties with anti-weld, anti-wear, anti-rust and anti-corrosion properties.
This oil allows an excellent evacuation of the thermies.

FIELD OF USE :

Thanks to its low viscosity, its wetting and penetrating power, this oil is especially recommended on most stainless steel, chrome and their alloys for tapping, drilling and threading of small diameters, sawing, turning.
It is also effective on special steels such as iron, cast iron, copper, bronze, aluminum and non-ferrous metals.

PRODUCT ADVANTAGES :

Free of chlorine and nitrites.
Insoluble in water.
Excellent anti-corrosion, anti-weld, anti-wear and anti-rust properties.
Non-flammable propellant.
Net volume: 97% of active material
Multi-position use: head up and head down

CHEMICAL DATA :

Appearance: brownish liquid
Viscosity at 40°C: 132mm2/s after evaporation of solvents
Pour point: -5°C after evaporation of solvents
Flash point of oil > 180°C

SPECIFICATIONS:

Case size: 65x195
Material: Tinplate
Nominal capacity: 650 ml
Net volume: 400 ml
Carton of 12 units
Propellant: CO2
Hazard label: SGH02 / SGH07
Customs code: 2710 19 91

DIRECTIONS FOR USE:

Shake can before use.
Spray on the surfaces to be treated.
Repeat the lubrication operation regularly during the work.
Its extension tube allows it to reach hard-to-reach places.
The aerosol can be used in the positions: head up and head down.

RECOMMENDATIONS :

Danger. Pressurized container: may burst under the effect of heat. Keep out of reach of children. Keep away from heat, hot surfaces, sparks, open flames and all other sources of ignition. Do not smoke. Do not spray on an open flame or any other source of ignition. Do not puncture or burn, even after use. Do not breathe aerosols. Use only outdoors or in a well-ventilated area. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Do not use for any purpose other than that for which the product is intended.