DEFINITIVE GLUE - Aerosol 650/500mL

Its effectiveness linked to its very high adhesive power, allows the gluing of light materials: paper, cardboard, label, film... but also in the car industry for the carpet, the fabrics, plastic and in the field of the do-it-yourself for wood, rubber..

Physico-chemical characteristics of the active product:

• Appearance: thick opaque liquid
• Odor: ether
• Density : approx. 0.86g/cm3
• Point of use : 10-30°C
• Thermal stability > 80°C
• Flash point lower than 0°C
• Dry extract : 27%

FIELD OF USE

Widely used in professional fields such as graphic design, printing, photography and car renovation, DIY, decoration... Good resistance to UV, water and weather. Does not yellow with age.

NOTE : this aerosol is for professional use only.

PRODUCT ADVANTAGES

• For final assemblies
• High adhesive power
• Effective on many substrates
• Does not yellow
• Weather and water resistant

DIRECTIONS FOR USE

1. Shake the aerosol vigorously before use until the bead sticks.
2. For a simple bonding, spray lightly at 15-20 cm from the clean and dry surface, after having previously degreased it with flash re aerosol (for porous surfaces).
3. Immediately after spraying, join the two parts together by applying uniform pressure.
4. The strength of the bond is proportional to the amount of adhesive applied.
5. For a very strong bond, use double gluing. Spray both surfaces to be bonded.
6. Allow to dry for 5-10 minutes before bonding, applying uniform pressure to the entire surface.
7. The same degreaser can be used to remove glue from the glued surfaces, but also to clean the nozzle in case of glue build-up.
8. Drain the can upside down after use.

Test on sensitive surfaces first.
Do not spray near live electrical equipment.
Use only when the equipment is not under voltage. Wait
5min before turning on the equipment.

RECOMMENDATIONS

Danger. Pressurized container: may burst under heat. Keep out of reach of children. Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. Do not smoke. Do not spray on an open flame or any other source of ignition. Do not puncture or burn, even after use. Do not breathe aerosols. Use only outdoors or in a well-ventilated area. Store in a ventilated area. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Do not use for any purpose other than that for which the product is intended.

PACKAGING

• Item : B770035
• Case size: 65x195
• Material : Tinplate
• Nominal capacity : 650 ml
• Net volume : 500 ml
• Box of 12 units
• Propellant: butane-propane
• Hazard label: SGH02 / SGH07
• Revision index: 4_070219