JAVEL GEL - 1L can

Cleans, disinfects and deodorizes toilet bowls. It restores whiteness and brightness to the toilet bowls. Pleasantly scented, it leaves a fresh smell.

PROPERTIES

Its bleach formula is specially designed for surface disinfection and hygiene. It cleans, disinfects and deodorizes toilet bowls. It restores whiteness and brightness to the bowls. Pleasantly perfumed, it leaves a good smell of freshness. The gel formula of the product allows a time of prolonged contact for an optimal effectiveness. Product complies with the biocide regulation EC 528/2012 and registered under SIMMBAD under n° 56741. Can be used in TP2.

TECHNICAL CHARACTERISTICS

• Appearance : Clear green liquid
• pH : 12.5 +/- 0.5
• Density : 1,03 +/- 0,02
• Perfume : Freshness
• Storage : For an optimal conservation until the expiration date, keep the product away from heat, light and frost.
• Type of preparation: AL - Other liquids intended to be used without dilution.
• TP2: Disinfectants for surfaces not in contact with foodstuffs.
• Active ingredient: Sodium hypochlorite (CAS No. 7681-52-9) at 15.45 g/L, i.e. 1.5% active chlorine.
• Contains among other components: (Regulation (EC) No. 648/2004) Less than 5%: anionic surfactants, non-ionic surfactants.
• Chlorinated bleaching agents. Disinfectants. Perfumes.

DIRECTIONS FOR USE

Modern surfaces (floors, tiles, plasticized surfaces), for a cleaning-stain removal action:
- Dose 60 ml/m².
Difficult stains:
- Use the product pure.
- Leave to act for 5 to 10 minutes.
- To rub using a sponge if need be then to rinse with drinking water
- To wipe, dry or let dry with the free air. Rinse water and product residues should be directed to the sewer system for treatment in a wastewater treatment plant.
W.C. / Sanitary:
- Apply the pure product under the edges of the bowl and the walls.
- To let act the time of necessary contact.
- To brush if need be and to activate the water flush or to rinse abundantly with clear water.
The product is also available in 750 ml duckbill.
Rinse surfaces with water and wipe or dry.
Surfaces can be pre-washed with water to remove excess dirt.
Rinse equipment used in the preparation thoroughly with potable water.

STANDARDS

Bactericidal - EN 1276 in dirty conditions at 20°C in 5 minutes.
Levuricidal - Fungicidal - EN 1650 in dirty conditions at 20°C in 15 minutes.
Mycobactericidal - EN 14348 in dirty conditions at 20°C in 15 minutes.
Sporicidal - EN 13704 in dirty conditions at 20°C in 15 minutes.
Virucidal - EN14476 in dirty conditions at 20°C in 15 minutes.
Virucidal on bacteriophage - EN13610 at 20°C in 15 minutes.
Virucidal efficiency covered on Coronavirus.